it doesnt squirt fuel but if i open the accelrator it just drips out of the jets i think

im going to try my old carburettor

whats a good replacement carburettor?

nah it doesnt squirt fuel when i put the accelerator to max,
even if i put my hand on the top of the carbi to stop the air no fuel goes onto my hand and i cant feel it want to squirt out?

do you reckon its a dodgy carburettor

the spark is fine i recently put in electronic ignition and had a auto elec do my wiring

the fuel level is at the dot always even if i crank for like 2mins its at the same level

i am located in narre warren but its been sitting at my workplace for like 1 month now

well i crank the engine and it wont start
even if i crank for ages on full throttle wont start
choke works but doesnt raise the idle at all

yes the float level is right on the dot

the carbi was made in china do you think the jets might be different?
or for higher altitude
would i be able to use my old carbis jets?
i havent opened the new carbi or done anything with the jets

il come get it next week if you still have it

yea asoon as i put on the new carbi because the old one was running funny idles kept jumping around from leaks i cleaned it and it wouldnt work when i put it back on

so i built this other one appreantly for the a12 ,120y,14.15 and it seems like its not sucking in any fuel but the fuel bowl is half way all the time even if i crank for like 2mins straight?

yes it does but i took the pin out.
and put a screw with the same thread in there to block it
is this bad?

what do you reckon the best carburettor replacement for the a12 is?
like a stock carburettor not a weber

i bought a carbi off the internet some nobrand carbi made for the a12,a14.a15 but it doesnt seem to want to start with this carburettor

i just put electronic ingnition in and compression is good
also running an electric fuel pump

what do you think

im interested where i would be able to get a EGI inlet for my datsun a12 motor
ive searched with no luck
is there a different make or motor with a compatiable egi inlet manifold?
also need to know where to purchase unless i have to go wreckers hunting

any ideas?