A lovely used but very good condition set of A12 Arias forged pistons in +040 with gudgeon pins and teflon buttons and a NEW set of rings. These are seriously strong pistons and (by the look of the dome on top) fairly high compression. Ideal for a normally aspirated screamer or a turbo or supercharged motor (with some machining to remove the dome and give a suitable c/r). I suspect that a new set would cost somewhere between a small fortune and medium fortune. I'm after 200 bucks. I can send you a picture if you want to email me.

bump!

Twin 40 DHLA carbs on a manifold to suit A12 engine. I got these from New Zealand some time ago to put on a 1200 in my 1000 coupe, but I now have an A14 fitted so these are not suitable for the A14. They came from an original 1200SSS - so they will work very well on any A12 motor. Looking for $550.00 I'm in Melbourne but it's easy to post them. Can supply pix.

1200SSS1200SSS article

NEW 1200 COUPE CAMSHAFT FOR SALE

I have a BRAND NEW canmshaft for a 1200 coupe. It is for a 71-73 model A12 engine, the one with distributor at the front, not in the middle of the block. Made in Japan, all in original packaging and absolutely never used. Much better than a reground camshaft and also much cheaper! In Melbourne and priced at $75.00

I am very interested in the 6 inch minilites. Have you got nuts (for the wheels ) ? Will they fit on a Sunny or a 1000 or both? Any chance of a pic or two?

I have a 60A gearbox in a 1000 coupe. It fits in the transmission tunnel but only just! I had to chop a hole in the floor to give clearance for the clutch operating arm to work and make up a "bulged" metal cover to screw and glue over the hole. If yoy figure out where you need the clearance for this (and the reversing light switch which is also a pretty tight fit) you can beat a bit of a bulge into the floor at the appropriate position. This means fitting the gearbox up and marking where you need the clearance then removing and refitting again after you've done a little panel beating. You'll also have to modify the rear gearbox mount.

Ade if you want to sell a set of minilites (or look alikes) I am interested. Do you have a full set and how much do you want?

I can help you with a strut if you want to figure out how to get it from Melbourne.