He thanks man that article helped me a lot

I need some help in balancing the carburetor for my A15 engine. I see three screws on the carburetor two on the side close to the tappet panel cover and one on the other side. I know that on the side that has the two screws, one is the air screw and the other is the throttle screw, but i'm confused as to what the screw on the other side is and what it is used to adjust. The screw goes into the carburetor and it has a spring between the body of the carburetor and the head of the screw. Can anyone of you guys help me to figure out this problem that I have?

Does anyone know where I can get the engine manual or tune up guide for the A15 engine? If you'll do please send me the information, I would really like to get my A15 to work at manufacturers specification.

I'm looking for a drive shaft for my Datsun 120Y B210. Does anyone have one to sell or know where I can get one to buy. By the way does the drive shaft from the B310 works on the B210?

I'm recently hearing a squeeky noise from my right front spring, it only occurs when weight is applied to it and the steering wheel is turned at the same time, I tried spraying it with WD40, it stopped for a day, but it started again. Everytime I stop by a corner or to turn into a parking spot the noise comes up and its pretty embarrasing to be squeeking especially when the ladies are around (LOL). If anyone knows what can be causing this and what can be done to stop it I'll really appreciate the help. Thanks.

I recently noticed that my left inducatir or signal lights are not working even the one in the dash board, I'm not even getting the tick tick noise that it makes. I tought was a fuse problem but it wasn't and the right side is working fine. I checked all the bulbs on the left side and they are all good. What do you'll think can be causing this problem and what can i do to solve it?

I'm trying to fit a Skyline R32 GTS steering wheel on my Datsun 120Y, but I ran into a problem, the center bore of the Skyline steering wheel is bigger than the steering column on the 120Y and as a result the spline like teeths are not matching up, what can I do to accomplish this modification? Any ideas will be appreciated.

I have an oil leak in my engine, but its very slow, leaves like two or three drops of oil on the ground when the car is parked up. I cleaned the engine to monitor where its coming from and I noticed that its coming from around the fuel pump. I checked the bolts thats holding the pump and they are fine, but the leak still persists. My question is, is there any other part that can go bad on the fuel pump to cause oil to leak?

I guess if I retention the spring leaf on the right it will even out. Both my front springs are new with new shocks so I guess I would only have to do the back.

Recently I noticed that the back of my Datsun 120Y is not even, one side is droped lower than the other, that is the right side is dropped lower than the left side. What is causing this and how can it be fixed??