Priced to sell!

http://cgi.ebay.com.au/ws/eBayISAPI.dll?ViewItem&item=180136458285

Doh! Thanks mate, fixed

Haltech E6X, Quality One Looms Datsun 1200 Loom, LS1 Coils & leads, boost solenoid, 3 Bar map sensor, Idle motor, water temp, air temp...

Everything to plug into a CA18DET Datsun 1200, great for upgrade or project.

This was used for only a short time and car was wrecked for parts, like new.

Over $3000 worth sell $2400

More info:

http://datnet.org/forums/viewtopic.php?f=36&t=10577

The sedan shell is set to sell on eBay in just over 24 hours.

eBay Auction - Datsun 1200 4D Sedan Shell

both were running when removed.

make an offer i just want them gone

I'm out near Penrith.

I have 2 a12's

Chrome is headlight surrounds, eyebrow moulds, bonnet mould and lower moluld.

No bars left.

I think i have one under the house that was sprayed and the partly paint stripped, from memory the bar itself was OK.

If you want me to take a look and send a pic e-mail jon@nexcentpp.com

Shell is now up for sale.

Does not include struts, tail lights or any suspension. Can supply rear springs and some front end parts. New apron, seats, new hoodlining, new carpet, new rubbers all included.

I need this gone very soon.......


http://datnet.org/v4/component/option,com_adsmanager/page,show_ad/adid,2/catid,5/Itemid,52/

Re: the Maddat conversion...

The 200B hub needs to be both machined down in diameter & also depth to maintain correct offset, otherwise the alignment between rotor & caliper is incorrect.

Sure, some people may be able to do this, but the majority will not. If this is not machined correctly, the results could be catastrophic.

The caliper also needs scalloping to clear the edge of the bracket.

Maddat is happy to do kits with people supplying their own calipers, but this is the minimum they will do.

I bought this conversion, and see it as a case of you get what you pay for.

Only a few bits and pieces left people.

Parts for sale

Lots of 1200 doors, boots, intercooler + more. Click the above link.