Quote:
No mate it was a 720 housing and axles way to wide I gave it to a freind with a 720 ute he gave me a 4.11 ratio center to replace the one I killed on the dyno.

DANG I wish I was there looks like a good turnup and lots of quality cars
Ps: Lags did you get the forged pistons and rods?

Hey Bryce do you have any good video?? Id like to post some up.
Cheers Andrew

agreed a lot of paint coulours are just fads expensive ones at that give me a nice solid shiny base coulour anyday. B120dats ute looks awesome in red.

Today I set a new personal best time down the 1/8th mile drags. I had 8 runs all between 8.13 and 7.88 most where low
7.9's all in all im very happy with the setup 4.11 diff allowed me to launch in 1st gear without too much wheelspin and just pulling 4th accross the line. I had a few runs against a well setup KE20 corrolla running a 3tg 22psi full slicks ect it launced a lot harder than mine around 2 cars lengths over the first 30 meters but I started closing in top end.
He has run 11.3 at eastern creek I feel mine should be good for a mid to low 11.
New engine ran sweet all day hitting rev limit at 8000 a few times. Only one small problem have a rear gearbox oil leak again

Jeff I purchased one a year or so back from obrien windscreens wasnt very $$ the new rubbers and fitting cost more than teh screen around $250-$300 from memory

ARP do a bolt that works they suit a ford Pinto 2000 you will need two sets though as there are only 6 in a set you need more. They where pretty cheep too cheaper than the nissan stock items and in my opinion better.
Cheers Andrew
They are metric 10x1.0x30
Cheers

Check this video out this guy is unreal.
Utube Video

Thanks Jeff
Ill call dwayne tomorrow & will go see the blueslip guy next week.

Yeah Woody the 620 ute diffs have the alloy carrier 4.625:1 if it looks silver a it would be alloy a steam clean and some heavy duty alloy cleaner will bring it up nicley.When your closer to doign the CA18 install give me a call Im often over your way can give some pointers.
Cheers Andrew
Should look like this minus the disc brake setup