So i guess these are for jet powered datsuns??? Not to sure what a crocket is though!

I think you will find that gemini has the same splines. they are a Jap car after all!

Cheers

Matt

As it comes with an S3 crossmember my guess would be RWD.

Matt

If the CA comes with a loom how much?

Matt

please email with any questions.
Manifolds
Other turbo parts

Cheers
Matt

Sounds good. I'll be up at indy on the 23rd.... I'm only after one crossmember at the moment. I can give you an exchange too if you want it? Any chance you'll be at bathurst tomorrow for qualifying?

Matt

Mine would be a ford GT40 replica rolling on 18" x 9" and 18" x 12" wheels with brakes to fill them. It would be powered by a 20B running a supercharger and a quite-ish exhaust putting out around 600+HP. I'm sure i'm not dreaming??? if you were handy with a welder i guess you could do it for around $50K..

Matt

Yep stainless.
Andrew do you still have those crossmembers?

cheers
Matt.

Yes it will. It is actually shorter than the CA18 box. It would be fine in a 1200. I ran one in a bluebird running 10psi for 2 years without any probs so the light 1200 will be fine. advantage would be the shifter would be around 50mm forward.

Matt

Hey steveo.
I have low mounts and high mounts available. Low mount bolts turbo into factory position so you can run standard dump pipe, oil and water lines. Manifolds come with gaskets and studs/nuts.
low mount $240 delivered
High mount $270 delivered
Will do a low mount and stainless dump pipe for $300 delivered.
Quality is very good and they aren't light and weak as suggested. Will also give a warranty.
CLICK HERE FOR PICS

Cheers
Matt
www.gofastparts.com.au