hey Perth ute do you have any pics of your install sounds interesting thanks...

hey with strokking an a15 if you really want you can get the crank ground and get some of set bearings made up that will increase by a little bit i got 60thou with that hope it helps...

Hey all i have a a15 as the topic surgests and i was thinking about puting msd on it...i know most of you will say its a waste and the ignition that i have now is enough to do the job...I was searching a while back and i seen some one on here trying to sell his msd setup with dizzy ignition module and coil...i was wondering if any of you had a part number for the dizzy it self...i went onto MSD webs site and looking at the catalouge they only make them for v8 or a VW...which brings me to ask if the VW dizzy fits onto the A series motors. or evevn can i use the bluebird dizzy i have now and wire the msd ignition module up to it...

I hope some one might be able to help Thanks in advance...

Hey apparently there is a ute going around in sydney with some vault crystals any one heard of that or got any pics?

Yeh hey all ummm i mean chrome wheels as we see in the pic's will a 17x6 wheels fit in a 1200ute

Hye all i was wondering if any one had any more pics of datto's with chromies on them thanks...

P.S. I know most of you would dissagree but they look good if there right...

Hey all you south africans out there i was wondering if any one over there sold any good performance parts over there for the A series motors...parts like turbo kits pistons mainly but im sure if you mention other people will be interested in. interested to know Thanks...

Hey dont feel dum i think we all fel for this one...on my a15 i have a cast A14 on the left hand side is that whats your talking about. The engine number is located up on a machined surface near the dizzy...i hope this helps.

Its more for when you go around a corner to keep the oil in the botton of the sump so that the oil pickup is always drowned in oil. it also keeps the oil away from the crank which wil slightly take more energy to turn (every bit counts) any one else add to that...

Yes it is i think ill get one modified from my local sheet metal shop thanks all for your help.