Spray you some paint down the exaust from front to back,run the stew out of it , then look underneath ,wherever the paint is burned off -----cut it.

I guess if I can fab one to fit a holley 350 cfm carb to my E-16 , then I guess I can fab one for a weber to my A-14.

Thanks alot, I'll try this when I get home . I'm more of a hands in the grease kind of person , but I catch myself on this pc more and more --- learning,lol

aww come on guys ,find one of your buddies that has a pipe bender and make a set of yoyr own, I did ,and its not as hard as you think.

This cars body resembles the honey bee , haven't seen one in a while though so I may be wrong.

any info. on where I can find an adaptor plate for a 32/36 weber for an A-14?

I think the ute is very cool looking, just wish we had some over here, and as for the mazda , I haven't seen any of them around here at all.

Hey guys , can sombody tell me why didn;t NISSAN sell the ute in the U.S. ?

Here in the U.S.there was a Z-20 ,Z-22, and Z-24. The early ones had 4 plugs and then they went to 8 plugs a little later.

mine is an old 1973 chevrolet half ton truck with a tool body on back to hold all the tools and extra parts --250cid inline 6 split headers duel holly 350 cfm carbs. truck is a rust bucket though.