hi everyone. i was just reading the a14 & a15 install in the tech section and it talks about making new mounts for the a14. would it be possible to just fit a 1200 ute crossmember (if u could find one) and it will go straight in? thnx
DAVE

well i am gunna put fuel infection ( injection on it) would this be better than the carb?

i thought the holes for the castor rods were different on the stanza comtrol arm than the 1200?

hi every one i have just picked up an a14 and i am gunna slap a little on to it. can any one give me a few pointers on what need to be done head, piston/conrod, and block wise thanx
cya DAVE

i have done this conv. it is a good one too. i found that the 120y castor rods didn't fit neither do the 1200 ones i had the 120y one machines down.use the 1200 springs cos it looks like crap with the stanza ones. get new 1200 king springs they cost around 150-169 bucks. it also helps if u tell us where u r from hope this helps. pm me if u need any more help

hi all. i have found it easier to use door pods if mounting any speakers in the doors. by doing this you dont have to cut any from the door itself. although they can be a bit expensive they are more practical and the look so much better
cya dave

i am looking at putting a ca18det in my 1200 coupe. wat sort of money would i be looking at to get an engine of the sort and where can ig et one? wat about a ca16 are they any good? would they be a cheaper option than the 18? does anybody know of a good suspension specialist in brisbane? thanx any help would be good

hey all this maybe a dumb question but what sort of money would an electric blue pearl 1200 coupe, mild a12 with downdraught weber, stanza front end and 2 sets of mags. decent interior go for coz i am thinkin about sellin mine
thanx DAVE
there is also another a12 engine but it has been fully striped

here is a pic http://datsun1200.com/modules/myalbum/photo.php?lid=373

hey
WEBERS :) ya can't go past 'em. a set of 40's or 45's would be good but u will have to get it jetted properly otherwise fuel consumption will go even further out the windowthey r pretty expensive but they r a brilliant carby
hope this helps DAVE
ps you could even use 38's but theyr are hard to find

hi guys i have just put a 32/36 DGV webber on my 1200 coupe and i was wondering does anybody know where i can get the gasket that goes on the bottom of the intake manifold between it and the exhaust manifold? does this make sence to any one?
i'm confused oh well any help would be apprieciated
THANX
dave