just wondering if people have managed to source new rubber gaskets for sedan tail lights??? i was thinking about just using a sealant/gasket maker type product but was wondering what others had done (nothing came up when i had a search). Cutting a new one could be a mission due to it not being a nice easy flat gasket like a coupe.

Try changing the (IMG) to lower case eg (img) on both ends of the link

I wouldn't use por15 on roof and doors, to hard to overpaint and is affected by u.v. if exposed to sunlight

draglinks should be the same, but the aftermarket ones are usually off a 120y with a kink in it, whereas 1200 is a straight rod. You didn't import a USA left hand drive one?? have heard of issues with these fitting??

the only calipers i have seen that stick out that far and give these issues are 120y

it'll be the four bolts that bolt the axle's into backing plate, have a flat side on head to stop them spinning

they made 4 speed 60a gearboxes as well so you wont be able to tell just from the size of it, they look identical to 5 speeds

yep, they're installed and work well

do you mean for front or rear belts (or both)?? i got some from repco a couple of weeks ago for the front, were multi fit retractible klippin brand. If you get stuck i could find the part number. Have never looked into the rear though. Would 1200 sedan rear seatbelts fit?? isn't there a high mounting point in the rear under the hoodlining??

Diff was standard 1200 so 3.9