i have to disagree shockmount is nowhere near the ground.Tyrie

I have big tyres on back and soon going even bigger

maybee with small wheels and tyres it might

but if ya wana flip ya leafs flip em

with the blocks i dont have any exhaust problems and im running a 3'' all the way and its dumped on the ground and still legal all the way around

how do you no where im putting it.
Its going no where near the original location

so how did u figure out it will fit???

How big is the booster????

and whats the size diff between auto and manual booster????
in mm

I have 15''x4'' rim
with 115x70 tyre

And outer rim hits strut not tyre

I tried 17 with 205 tyre and the same problem

And my 15'' rims are half the width.lol.

hey mate
i have the same problem

and i have 15x4 front runners.
120y disc brake struts.

Im getting spacers welded to the back of the rims then balanced.

For some reason 1 is closer then the other
i have put washers for now to see how thick the spacer has to be and its about
20mm 1 side
15mm the other

Also on the back im running
205x65x15

the rubber just misses the leaf
I might get rear wheels modified to.

Lots of people run spacers
when u go 2 a big tyre shop in syd
half the time theyput spaceres in when u buy wheels.

i think the only bad thing rego wise is they have to be part of the rim or part of the hub
Dont think it can be loose

Some1 else may be able to comment on legalness!!!!!!!!!!!!!!!!!

Some 1 else may have other EASY ideas around it.

120y
180b
200b

Will pick up between nowra and sydney
Or will pay for postage to send it to me.


Also has any 1 got dimensions of these boosters as i want to put my clutch master cylinder in but i cant untill i see how much room i have

i said ill buy it weeks ago and im still waiting on postage costs

I used 4'' lowering blocks
Worked good but need spacers or use 16'' rims or bigger as it rubs on shock and u bolt mount thing.

If u dont care bout handling and illegal practices go with the lowering block.

What is a common car that has these type of clutch cylinder

Does gemini
as i can get 1 for wrecking

just having a look is it possibli to put in normal position and make a custom rod that runs from the end of the rod to a fixed position past the pivot point...

Any1???

So in order to do this i cant run a booster as if it is conected below the pivot point it will hit booster.
Is this correct as i dont have a booster yet so cant try.

I was wondering how it works if the rod goes in and the pedal pushes away when pressed it just seemed impossible.

So are my options
Remote booster or no booster.
or
Under dash clutch slave setup

Can i run it realy low like
under the steering colomn where the floor is an angle.and run a remote reservior.

Any ideas how any1 of use have fitted a clutch master setup????