i have just noticed it now becouse i have put in richer needles, it wouldnt rev past 5000 before.

just curious if anyone has had any sort of vibration from about 5000rpm onwards. it feels like a resonance vibration. the motor has done 3000 km since rebuild. the motor was balanced when built, head ported, 30 70 cam, higher comp ratio. the su carbs and manifold really start to buzz and vibrate, I can feel vibration through the pedal and on the floor pan and fire wall of the ute. any help or info would be appreciated.

my a14 head with 280 276 cam 295 lift uses 2lt camera springs for the hieght not sure of the inner springs but they have been shimmed top get the right tension. the engine builder tried red 202 springs but they didn't have the hieght or the tension, im not sure which.

is dattoman local.

hey chris should catch up want to show you they new a14 it goes sweet!!

if the 180b disk should be up for it then i will get the ebc's.

the pads are old so need replacing but the fluid is only 2 months old

Hi all, got my car tuned up after a month of breaking in the engine. took it for a squirt and after two hard brakings they stoped working . when they cooled they were all right.

Is it worth spend $160 on EBS pads or should i get better disks? I think i have 180b disks brakes, should these have good brake capabilties for hill climbs and sprints?

thanks

i have a spare round kph speedo in perth

my vacum advance is buggered and i was wondering if i can do with out it.

i have a pair of hitachis, i have been using them on the motor for 9 months. i was chasing a rebuild kit for them but was told that they are not avaliable. they ran to rich and were worn out.