Hey I listed one for 99 cents and no one bought it

Hi have one for sale if your interested just PM me for details

Hey a good plug to try is Bosch Platinum Plus they are about $7 a plug and I have had very good results with them. Choose standard heat range and see how they go

And over 14 inch. 15 Max

Hey remember these old cars came out with 4/5 inch rims, so anything over 6 inches is a waste.

Tailshaft should be about 50mm in at normal load, mark shaft and then remove it to see how much of it is in. If you jack it up to check it jack it under the diff.

Well the project is all coming along fine. Cars been painted Devil Yellow, Been chasing bits all over the place, thank god for ebay and Datsun1200.com. Will be uploading photo's soon. Here is a quick brief but. Kb10 Coupe. Enkei 13x6 Rims, Disc Brake Front end, Twin 40mm Solex's on Redline Manifold on 40thou oversize A12 Motor, Extracters, Lightened Flywheel,Cam,etc. Sunny B310 4 speed Gearbox. Lots of other stuff on the way. Updates coming

Hi, I reckon 0 to neg 0.5 is all you need for road use and tyre wear, run as much positive caster as you can adjust in, and start with about 2mm toe and then adjust toe to change turn in and tyre wear. If it scrubs the outside, to much toe in, if it scrubs inside to much toe out. Hope this is of some help.

K-Mac did make an off the shelf kit. The front bar bolted directly to the control rods with U-bolts and the rear had U-bolts mounting it to the diff and Brackets bolted to the chassis rails. I contacted K-Mac who can make up the Sway Bars but they are $330 each which seems a bit expensive. So I might look around to see what else I can make fit.

Hi, I'm looking for a set of sway bars to suit my Datsun 1000 Coupe. I use to have a set of K-Mac Bars on my first Datsun 1000 years ago, was hoping someone had a set lying around that they might like to sell. Any brand would be fine.