where do you find the bumpers?

so the head i have located is the mazda 1.6 b6t out of 323 gtx awd turbo. this should work ok with this set up right?

just had to drill one hole bigger in the crossmember as the s13 has a shouldered lower control arm bolt. you might need to check into the tie rod end that will fit. I went rack and pinion off the s13.

Thanks and welcome to the forum. I used both, i cut out the mount section of both and swapped into the b310 leaving the bottom of the b310 one intact for the length. it took a couple of tries to get it right. but i was also putting in the rack and pinion from the s13. Good luck with your build.

Very nice Ernie, looking very good i haven't been on here in awhile.

I put 15" BBS's on mine it has the sr in it, it has been quite awhile since i updated my thread but good luck the your build. Here is a link to my build.

http://datsun1200.com/modules/newbb/v ... =ASC&type=&mode=0&start=0

Sound like this is starting to pan out, yesssssss

I know i would be up to make a donation, for the inside info, already sourced some of the parts, but would love to get the details on the front parts, oh by the way looks great awesome job!!!

might have a A12 pan on it, pan doesn't have budge for the dipstick

I don't have any spares either, but i will check with Morrison.