Thanks a lot pal... U guys Rock me up!! I think I've made a decision in my mind..
I am going to rebuild the dead motor.

Now chasing a Single DCOE inlet.. Cheap one :D

I mean after the motor run back..

Can I get the part number? See if the price is cheaper here...

How much is the price range for those 8 pieces?
either new or used...?

Yeah, only those 2 motors (complete running) come around at fair price. If I found any A15 in the price range, at the moment, I'll go for it.

Thanks for the ideas guys. For the short term, I just want to run them stock.

Actually I feel more to rebuild the A15, but the costs is killing me. Those 2 options might be a short time for daily use until I raise fund for the rebuild.

Yeah, I mean the one with 180kph Speedo...

I know the 160 one is off 1200, but not sure the another one. It has pointy glass.

Found this gauge and marked by paint B110.
anybody knows what this gauge off?

Hi,
I got a bad time this month. My A15 con rod bearing and pistons jammed. Might be worth an engine if I want to rebuild it. Thinking to swap the motor with either a rotor or 1.8NA.

The 13BT is 500$ and CA18 is 800$. I am not worried about the installation cost. Just curious about the reliability and the process.
which one easier, more power, and spare parts..

Any idea or advice would be a cure for me. So sad to look my 1200 just sitting can't roll..
thanks..

Good day guys..
I am looking for any brand of single DCOE manifold for my A15.
willing to pay about 50$ for any used condition.
Might need to be posted to Malaysia.
Thanks,
Bob