How much clearance do you have between the lowest point of 4 link and the ground? Is it still legal? Where did you get the coilovers from?

PM'd

Hi guys,

Just wondering if any of you would recommend an engineer who is datto friendly in Brisbane.

Cheers

And I know the CA ones are off set. So I think in the opposite position you are able to get an extra 5mm clearance off the firewall.

Also just picked my crossmember up from Kev. Was also curious about this. Kevin designed his crossmember to the standard mounts because that is what came in the front cut. If you find another mount the same height as factory, they will still work. I will be using the factory style ones (not genuine) as they are fully silicon and will provide a good cushion and Kevin recommended to. But of course, each to there own.

Thank you very much. Yeah keeping internals standard at the moment. Has go pipes custom manifold, custom CPC intake manifold with 66mm Throttle body, 800cc injectors and microtechnology lt10.

Hi Guys,

I'm currently building a Datsun 1200 ute (will post build up as a bit more progresses)

Just trying to decide on which turbo to run, I have tried searching and looking, but there does not seem to be much information on the GTX28 turbos when it comes to what people have done.

I have a CA18det and trying to decide which of the GTX28 turbos to get.
Gtx2860
Gtx2863
Gtx2867

The ute will just be a street car. So after something not to laggy but still powerful enough.

Any thoughts??

Thanks