hey RC, If you don't mind me asking, what was the approx. cost of the engineering process. You hear so many differing opinions from the high hundreds into the thousands. (Good job by the way)
DD, I am not sure if the aussie delivered seats were different, but I have a b210 with seats. I was going to do as you suggested and swap the rails over to put the seats into my 1200 coupe but from memory they were a wider seat. I'll check and confirm. cheers Bruce
just to add my 2 cents worth about using the spot weld drill bits. The key to getting longevity out of the drill bit is not to have the drill going too fast. After you have done a couple, you will find that it is a pretty quick process to get through them cheers Bruce