ya that is wat i intend to do. s**t . hahaha

thanks for ur info anyway. just that need some pointer and a place to start of. ermm maybe i will go and look for books that teach us who to do it.

will keep updating the progress

Hi there,

i recently have finish my 1200 ute project and now i am buying a 120y for another project with SR20 DET.

i am just wondering is there anyone out there have tried to put the nissan silvia (SR20DET) rear axle into the car too.

i hope i can get some pointer fo how can i do it and some picture will help alot.

thanks

ya there was this group in taiwan that have hell lot of this long wheel base ute and they only have stock A15 engine in it but still can drift but alot of work to tail out.

but i think for sure u all know there is a guy in japan that have a yellow ute (old timer) that also drift with A series engine.

erm if only here that we can drive without air con

it's 1976.


the 4AGZE from the AE 101 was rated 165hp on engine that was on front wheel drive.

the car have quite a good pull in the beginning but it die of after 5300 rpm.

thanks guys,

anyway i running a stock 4AGZE inside with AE86 rear axle and stuff basically i buy the whole front cut and dump it it with an extra GZE engine. it is to costly to build an A12 engine here. engine is cheap but aftermarket parts cost a boom.

i think i am the only one here to drift this type of car. sorry guys i did not qualify for that day. so no extra clips. but last week end i did go to a drift event and i'll try to get some from my fren or maybe this week end i'll get some cos we will be having one more event.

but it's abit tiring to drift this car compare to my old car.....

This is my second time drifting the car so nothing great about it. just to share. anyway this is a 1 1/2 year project which from last year july until recently only.

http://drift.com.my/forum/videos/sso4dot5/sso4dot5datsun.wmv

erm u mean that my ute would be quite the same with urs. i found it quite hard to push the car out from corner.

erm not sure .... hhehee... or maybe is my skill problem. haha.

it is very different from all my old car and this has no power steering.. ouch my hand is aching...hahah

HI there,

erm after 1 year and 4 months i have finally finish my UTE ......

yesterday morning went for an drift event and drove the car for one whole day.

it seems that the rear are to light and it is quite hard to push the front as the front are heavier then the back but i just wondering wat is the weight different between the front and back. i have search but no relevent info was found.

my spec is

4 AGZE engine infront
AE86 cross member and steering rack
AE86 adjustable suspension (aftermarket) with nuckle and disk
AE86 rear LSD and rear axle with disk brake
Long Champ XR5 15 inch rim

i know putting in a toyota engine in is abit off. but to put an sr20 or ca18 i think it would be heavier infront and from 1200cc to 1800cc is way too far for our regulation here.

hei bro is there any chance to get the ute rear tail lights and the rear tail lights panel
thanks