g'day guys.
been a while since i have been in here but the time has come to gather the bits to do the body on the wagon.
does anyone know where you can get the rear side window and tailgate window rubbers?

cheers
jason

looking for some wheel 15x6 wheels for my wagon. will consider anything but would really like a set of simmons.

cheers
jason

G'day.l looking for all panels for a wagon.

Also need some better diff ratios to suit my engine. 4.6 would be a good start. For a h165

Also looking for a set of 15in wheels. If I can find something I like I will change out the ones already on the car.

In Perth prefer.

Cheers

What sort of condition is the door and tailgate?

Cheers
Jason

i would like to fuel inject and go full 3d with crank angle sensor.

get it stepping towards a turbo if i wanted to 1 day.

i largely want the efi and caS to get the most out of it. efficiency and power

plus the only difference in price would be for the computer. webers are pricey!!

edit.... i hate predictive text!!!!

all the holdings down the side are off and the spot ties too!.


edit: also the back view is lowered but the front view the raised height it meant for inspection at... only because the exhaust was 10mm too low to pass and i dint want to take the chance.

Attach file:

---

  DSC02062.JPG (141.16 KB)


  DSC02044.JPG (151.79 KB)

no dyne yet. i need to to make sure its not too lean on the top with the re-jetted nikki carb.

im tryin to dig up an outside pic

i'll state the obvious... under the bonnet!

it is a bridgey

Attach file:

---

  2012-03-05 11.33.02.jpg (175.90 KB)

for those that are interested.... my wagon is now finally licensed with the 12a. was quite straight forward when done properly.

I'm now overseas for a few years so i can't drive it!

thanks but i ended up getting one from nissan.