I've just run into another stumbling block trying to wire up a Microtech loom with all the Nissan CA18DET plugs. After finally unclipping the terminals from within the original Nissan crank angle sensor I headed on down to a auto electrical wholesaler. He advised me that he had no terminal that would match the original Nissan ones. I then went to an auto electrician who referred me back to the wholesaler I'd already been to!!
I then tried the Nissan Dealer who said Nissan did not sell parts for wiring looms only the whole loom. I know I can solder the original wires onto my new loom but I was hoping to avoid this.
Does anyone know where to get hold of these terminals??