I'm clearing out all of my old Datsun parts to make cash for another streetable scooter while I rebuild my Vespa 150 Super; so I'll have a bunch of 1200 parts for sale over the next few weeks. All prices are in USD.

1200 Sedan GT4/5 Racecar- Project 96% Done!

This is a rolling chassis, the car has a full custom cage (needs minor welds to be perfect), fully adjustable custom suspension with modified 1200 struts, adjustable coil over springs and sleeves, I believe it has Koni 3-way adjustable inserts but I'm not 100% sure (car is in storage and I cannot verify), it also has 240z front rotors with big a$$ Toyota 4 piston calipers and adjustable camber plates, Datsun Competition rear leaf springs, MASSIVE rear custom Sway Bar, Aluminum 240z finned aluminum rear drums, bubble type fender flares (rears are not yet attached), Tilton hydraulic system (w/ adjustable bias) with full steel braided lines, lightened doors, Fiberglass hood, 2 extra sets of Hoosier slicks (1 mounted set of Avon's on 14"x6" Infinity alloys ) - also included are ALL the extra 1200 race car parts that I have that should complete the build, including Aluminum race seat, glass, extra parts, extra dash, electric fuel pump, after-market gauges, 5-8 alternate rear gear sets and many other parts!

No drive train matching super drive train but I will include - 2 factory 4-speeds and an formerly running A15 - no dizzy or fuel pump. There is no title, as it was bought as a race car and was going to be strictly OFF-ROAD and trailered to events.

The suspension was somewhat modeled after the Datsun 1200 Competition Suspension Manual.

You will just need to finish painting it (Porsche Guards Red) or paint it your favorite color[s], add your preferred drive train, tighten down the bolts, dial in the suspension, add some lexan windows (or the glass ones included - pop outs, rear or front glass) then you'll be set to hit the track!

This car is located in Albuquerque, New Mexico will need a car trailer and maybe another SUV/VAN for the rest of the parts. Sorry, I want it all to go so I will not break up the race car or the parts winner takes it all, more photos (20+) can be seen at www.datpart.com

I'm asking for $2500 or BEST OFFER - I will also seriously consider a trade for either a daily rider Genuine STELLA or a Vespa Rally 200/P200/PX200 (No "Imported" Asian scooters!!)

VISIT DATPART.COM for even more and larger images!!























Motorcraft Carburetor - Weber DGV 32/36 Clone

This used rebuildable Motorcraft Carburetor is a Weber DGV 32/36 clone. I believe that this was installed on a Datsun 1200 many years ago as the linkage looks right for the 1200 (no promises as I've never run this carb) it's been collecting dust as it has been sitting around for 10 years or so in the shed, the choke is water heated and the connector need to be reattached. Again this will need to be cleaned and rebuilt. There is also a small chip on the filter ring in the picture directly below, it is very small and should seal just fine with an air cleaner in place.

* This carb is stamped R6655 1








- $35 shipped in the US and actual for global shipping.


Datsun 1200 Front Box Flares and Airdam

This is a front set of Box Flares - sadly it's just the front pair and the airdam.

The Box Flares











- $250 O.B.O. + shipping


Datsun Hamburger - 70's Logo "Off Set Vinyl" Decal (6.5 inches) - White Background




* ONLY 2 IN STOCK!

- $7 shipped in the US or $8 Global Post


Datsun Mini Hamburger Pair - 70's Logo "Off Set Vinyl" Decal (1.75 inches) - White Background




* ONLY 3 Pairs IN STOCK!

- $4 shipped in the US or $5 Global Post


Datsun Mini Meatball Pair - 70's Logo "Off Set Vinyl" Decal (2 inches) - White Background




* ONLY 3 Pairs IN STOCK!

- $4 shipped in the US or $5 Global Post


Datsun We are driven. - 70's Slogan "Vinyl Die Cut" Decal (5.5 inches)






* ONLY 5 BLACK IN STOCK!
* ONLY 5 DEEP RED IN STOCK!

- $6 shipped in the US or $7 Global Post


Datsun Fairlady Z - 70's Logo "Vinyl Die Cut" Decal (11.5 inches)




* ONLY 1 BLACK IN STOCK!

- $10 shipped in the US or $12 Global Post



I'm a PayPal Verified (908) member and I can also post these to eBay for those that would like extra security.

You can either email me at datpart@gmail.com or drop me a PM here.

Thanks!

Rich

These are still available if there is interest.

Just drop me an email

I will also be getting photos up of my 1200 Sedan GT5 Racecar (full cage, coil-overs, 240z/Toyota 4 piston calipers, Datsun Comp rear springs, flares, Tilton hydraulics - No motor or tranny) which is also for sale for $2500 OBO.

- The Yellow 510 is now SOLD!
- The 1200 Headers are also SOLD!

I know that someone wants the carbs... so offer up

- The Yellow 510 is now SOLD!
- The 1200 Headers are also SOLD!
- The 63A Dogleg 5 Speed has also SOLD!

LAST WEEKS SALE IS OVER.

SORRY GUYS!

SOLD

pm'ed you about the brake booster...

email me back , thanks.

JC

PM'd you on dash and intake.
Hey guys, I aint the only one in NM with a 12....bahabahaha

WICKED!