I'd be keen for one as well if I was sure it was going to fit with the CA in place. Most fabricated CA strut braces I've seen are higher on the drivers side to clear the inlet manifold.
If anyone with a CA is getting one of these in the first round can they please advise whether it fits ok and if so you can definitely put me down for one in the next batch.
P.S. Boof, I'm in Melbourne (Frankston) so if you ever get down this way you could bring one down for a trial fit and then we'll all know for sure.

G'day

Im keen for one aswell, if you could put me on the list.

thanks

stu

this is from the front (obviously) there is a fair clearance right across the engine bay. don't think you could lift it much higher ??

someone with a ca please let me know if it looks like it will clear ?? or could you email a pic in the same angle of your engine bay to me ?
cheers

first 16 bars are :

edit 13/09/06 :

list has been added to the 1st post


still have to confirm if they will fit a 120y proprerly as to with a CA.

cheers guys

please put me down for 1

im definetly up for one aswell boofhead aslong as it fits over a ca
-cam

I'm in. Will save me some time in the shed. . . Looks better than anything I'd ever make. . .

cant be forgeting me, ill get one too

picked the plates up today, should have them all welded and ready to go mid to end of next week.

i'm getting prices on postage to adelaide, sydney, brisbane and perth. these will be general for the area you're in and added to the $130 for the bar (i'm too lazy to get everyone priced individually before they get sent )
for the melbourne guys i was thinking a mini meet up and pick up ?? ideas ??

lookin good, cant wait to get mine