hi i'm new to this forum but my 1200 is working bloody fine so ill come on the cruze.. guildford and freo area sounds good for a cruze.. :D maybe go up to hamburger hill??

yea mabee a short evening cruize for a burger or something.. for a starter...

are we any closer to a fixed day, place, time??

bolted new turbo up... goes for tune on friday.

Chris is being offline with net provider changing issues
Ask him again next week

Yeah wouldbe keen, depending on work ie i am home. Pitty that daisy prob wont be going any time soon. Still might come along to look.

OK it goes a little something like this!

Nizpro are having a annual dyno day on the 16th June (Saturday). $45 for 3 runs blah blah blah. Im pretty sure they put a thread up here too(theres one on ozdat).

So im planning

start at w/man park, thru John Forrest NP, out via parkerville pub way, down to mundaring wier, thru the zig zag and then to the dyno place in midvale. Probably having a stop-over at the dam for a breather.

Its about a 100km drive, maybe less.

I will have to call up the place where the dyno is being held an see what time they are doing it so i can plot a start time.

I will pre run it probably next weekend or something, maybe tomorro seeing as its raining.

All going well the wags will be there!

Not enough time to get the race motor turbocharged and into the wagon by then

But.... I could dyno the stock A15 for a giggle

I am home that weekend..

Perhaps I should get my arse into gear and repair daisy to get her running again... just for one last run, before the real work starts... Just needs a new timing cover as the last one coroded through.
Its either that or take the pootrol out. I could go as escort. Just got the new v8 fitted so it would be good to give it a run, perhaps dyno it at the show?

Donno how well your pootrol will handle the twistys though Well at least its a Nissan. There will be a couple of non dattos tagging along as per usual, but they have excuses!

The more the merrier.

I got a email back from the dyno shop, Xtreme Ford Tuning. they said it would be great if we turned up!

cool! that gives me more time as the new turbo set-up failed on the dyno on friday. turbo is fine but the crank angle sensor is not reliable so have to make a new one. should be done this week.