hey guys

im putting a ca18det in to my 1200 has anyone go to the trouble of getting these engineered!!! if so im looking for an engineer that has done one before my local engineer does not have a cule in what i want to achive and is going to sting my hip pocket

thanks

Datsun 1600 workshop in Bayswater have done heaps of them. They are usually good for advice.

Engineers usually only sting you if its rough and they have to get to dirty if shes all shmick as i imagine you would want it to be and done properly say with a Maddat conversion kit or One from someone closer. Then they usually cost about $400 to engineer it.

When i was doing my ca ute i got quoted $700 to get mine engineered. Have a look on the vic roads website for vass engineers to find one in you area

i rang the 1600 workshop and they dont do it the engineer has told me $1800 to get it done

1600 workshop do conversions... not engineering

i beleive (from a while ago) they use the engineer in baysater as listed on the vic roads site

people say better to see the engineer and discuss what you want to do than build it and show up in a completed car

keep hasseling me by PM and i'll get round to him as i've been meaning to do it

i can let you know what he will be looking for

Randy uses archie robertson in bayswater hard guy to get a hold of but he's always got plenty of cars and busses to engineer. My car was done by jeff watters in park orchids great guy to deal with but im not sure if he dose cars anymore

i have the list just dont no how to put it on this site help me

it's easy to find on vicroads website...

doen't need to be put on here