To get these onto your 1200 it'll take:

YOU to give me all of your money

Me to send it to you and, you to pick up a spanner!!




Nah, basically if you are pretty handy and have access to basic workshop utensils (I should say tools) you'd need to:



1. You need to measure whether 305mm protruding carbs will foul with the strut tower. Keep in mind this is 305mm without filters.

2. Fuel rail & gravity feed arrangement (these puppies like to be drip fed).

3. Little throttle cable bracket.

4. Tuning.

5. Filters/ filter box.

6. You'd have to have extractors or A14/A15 closed exhaust manifold or gx manifold to run these. Or you could weld the heat platform off on the stock manifold.

I should have rephrased what I said before. I have had a lot of interest but not one offer. I think the extra work scares people off....or the fact that they haven't yet measured before they inquire.