Browsing this Thread:
1 Anonymous Users
|
|
Re: Twin su or single 45mm side draft for l20b? |
|
Moderator  
Joined:
2001/5/3 7:04
From 48 North
Group:
Registered Users
Contentmaster
Usermaster
|
A single 45 on a plenum manifold will flow more than twin 38mm SUs.
The twin SUs should be more response and smooth, if both setups are tuned correctly.
Posted on: 2009/11/14 2:39
|
|
|
|
|
Re: Twin su or single 45mm side draft for l20b? |
|
Home away from home  
Joined:
2007/5/24 21:24
From Los Angeles,CA
Group:
Registered Users
|
Unless modified, twin 38mm S.U.'s are too small for a worked over L20B. Even a single 45 Weber or 44 Mikuni would be pushing it I think. With twin 40mm mikuni's on the dyno my engine couldn't get enough fuel at the higher RPMs. For a worked L20B I would go for twin 44 Mikuni's or twin 45 Weber's. Just my two cents.....
Posted on: 2009/11/16 0:10
|
|
|
|
|
Re: Twin su or single 45mm side draft for l20b? |
|
Moderator Joined:
2001/5/3 7:04
From 48 North
Group:
Registered Users
Contentmaster
Usermaster
|
Twin carbs only flow a bit more than singles, so if a Single 40 is too small, Dual 40s will be too small.
Sounds like 44s or 45s are the way to go for a modified high RPM L20B.
Posted on: 2009/11/16 0:21
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
