Sorry guys, I've been tied up with uni. I have packaged most of the orders that aren't waiting on alloy flanges and I'm hoping to have them away by next week Monday.

Alloy flanges should be ready about the same time that I send those off.

Once again sorry for the delay.

No sweat mate, you're doing it for nothing so I don't think anyone can complain if they have to wait a little around your life. Fair enough I say. What are you doing at Uni? What Uni? Hope it's all going well.

Alloy flanges will be completed mid-week, they were busier than expected and didn't get started till today. I will be sending out the mild-steel only orders today so you should get those this week.


I'm at UniSA doing my master of Architecture. If you're a structural engineer I could really do with some help in the next few weeks!! I've worked a fair bit with structural steel and portal framed buildings but nothing to this scale of the current project (new learning centre at City West uniSA - John Wardle Architects and Phillips & Pilkington Arch).

Chris

These guys (who had ordered MILD STEEL flanges ONLY)have had theirs posted just now:

Gylezy COLLECTED
Lamb_daiquiri POSTED
Tongy
Heathbruce POSTED
Aegis Ready For Collection
Tommo_73
davidbil POSTED
elemental_funk
DatsAndy POSTED
lethal_john
clyons8
benny
D [shims + flanges]POSTED

jmac POSTED
DISCO_BOB
DJF280 POSTED
LAGWAGON
ang94541
2QK4U
Steveo
diymark POSTED
thedevilshands POSTED
Strop POSTED

Datsunrepairsquad POSTED
Vixen
boofhead
Wurzel
Dattowhore Ready For Collection

Legend!!

Awesome.

I just gotta sort a carbon seal for my current turbo or get anther turbo then I can make my turbo flanges and I can finally weld up my manifold!

Nah us Mechanicals only did basic structural stuff. I'm probably best at mathematical modelling, control, dynamics (solid body, fluids etc.) since those were the things I liked the most. I'd help if I could.

Nice work with the flanges! I hope everyone posts what they do with them.

Alloys are here and they are VERY, VERY nice. Will have pics up tomorrow after uni or before if I can. Sorry if this is dragging out a bit uni is all-ahead-full so I'm a little bit strapped for time (its the wrapping, labeling, ticking off and checking off at the PO that is the hold-up).

Um DJF280 I haven't sent yours, sorry about that I had a mark beside your name on my posting list and simply assumed it had been sent. So don't worry yours will be away this week.

Chris

Good practise in Project Management! Something for the CV.

Pictures

Attach file:

---

  Alloy Flanges.JPG (162.65 KB)


  Alloy Flanges 2.JPG (162.98 KB)


  Alloy Flanges 3.JPG (146.22 KB)


  Alloy Flanges 4.JPG (164.67 KB)