HEY GUYS I HAVE A SET OF 2006 HONDA CBR1000 QUAD THROTTLEBODYS. THEY HAVE INJECTORS IN BUILT IN THEM AND A THROTTLE POSITION SENSOR. THEY HAVE APPROX 42MM THROTTLES. CHASING $250 ONO INCLUDING POSTAGE WITHIN AUSTRALIA OR PIKUP IN ADELAIDE.

Attach file:

---

  !B0tm9!gBGk~$(KGrHqIOKj4E)cgidzV(BMbdDfMYO!~~_35.jpg (11.99 KB)


  !B0tnL6QB2k~$(KGrHqMOKn!Ew9)B+CdZBMbdEl3L9w~~_35.jpg (13.92 KB)

bump. offers?

What was the plan for these?
a cheap efi setup for an a series? This would be a good path to follow i would think. If I wasnt planning on the turbo, I would definatly consider this setup.

That, and I dont have the cash for this sortof thing right now....

maybe Dundee1000 could add it to his collection of intakes

Any idea on injector cc?

who's paying Reuby?

and if you were to say go Turbo, Supercharged.. what's wrong with this setup???

Nice work Matto, GL with sale.

You guys should just try an offer, you may be surprised. Matto's pretty good with his prices.

Hey Matto,

What is the centre spacing between the throttle bodies?

And are they the type that bolt together in the middle i.e. two pairs? Look like it from the pic but can't tell for sure..

Regarding the injector sizing question above, dunno the cc rating but they are capable of supporting 160+hp @ 10000rpm plus

yea they are 2 pieces. not sure whta u mean by spacing. from where to where?

just the centre to centre between the bores i.e. centre of one throttle plate to the next..