nice work there brett ,cant wiat to put the a14 back in for ya haha

carps you should be chillin not workin !

you coming to the perth cruise carps ???

sorry to the owner of these pics but they are awsome and i have kept them to use as a refference :D

Attach file:

---

  photoforturbo1.jpg (69.74 KB)


  photoforturbo4.jpg (73.51 KB)


  photoforturbo6.jpg (85.36 KB)

well the engine bay is now completed just needs a polish and will start putting things back in when its all dry

Looking good Bretski!

its so funy cause the bay used to look like this

looks good, you can do my bay now- as long as your welds hold ;)

my welds are as strong as an oxe....most of my car has been done by a gas mig welder

nice wrok brett but i can see heaps of runs in the first picture ! they are running down the beaver panel thingo !

though you have a piont ,it looks heapos better than it used to ! and the colour wont look so bright once the ebigne and stuff is back in ,i thought my utes bay was too brighta white ,then when i put it all back in it stopped looking super bright

Those aren't run on the beaver panel that's from sanding as I wasn't going to paint it so I didn't clean it

well the motor is in, i have made a new engine mount just havent put it on yet as i left it at work so should be on tomorrow if i get a chance. I have also just finished rebuilding my air blower unit just need a new tap for it and it will be done, works a dream now, will post pics of it tomorrow