Hey guys,
I cant see my SR conversion happening until..... ever so might add a little to the A15 in the meantime.

So, what I want is a matched pair of side draught carbies to bolt on. I already have a manifold so just need carbies.

Would prefer a set of 38 or 40 DCOES. Something straight off a an A14/15 would be ideal. Don't mind having to rebuild them but would prefer not to have to go through the whole process of re-choking/jetting if I can avoid it.
Let me know what you've got.
Cheers.

Ewan.

I have a running pair of 40mm DCOE Dellortos
have inlet trumpets, and individual red foam filters.
Think they have 32mm chokes from memory
Pretty sure I have documented what emulsion tubes,
jet sizes etc they have but would have to have a look
Were on my A15 club car motor when I brought it
which was reasonably worked and was run on AvGas
however, I used for 600 miles on my mild tune
A15 on pump gas, and went fine.
So would be fine to just throw on and away you go.

Throttle linkage is by #4, so would benefit from a decent
centre pull throttle linkage setup between #2 & #3.
(didnt really worry me, but been told, it is better to
pull from the centre)

I am just transitioning to getting my EFI setup going, so these will be surplus very soon.

Unsure whether I will keep, or whether I will sell to fund my paint job.

PM, me what sort of budget you have, to see if I can be convinced to sell them.

In New Zealand, but posting to Oz not a prob.

Attach file:

---

  dellortos.JPG (28.97 KB)