Hi wanting an A series turbo manifold. If anyone would like to sell one. Thanks

I am making an A12 manifold this month.

Have to finish the SR20 currently but here is a sample of the quality the A12 mani will have. These will be weld up kits and for the A12 I will be selling them for $500.00 +shipping from the USA.

Do you also make manifolds that the turbo bolts to? (exhaust/turbo manifold). That one there looks like an intake manifold?

Matt you thinking of making your own ITBs as well?
http://www.ebay.com/itm/OBX-RACING-SP ... :9eQAAOxyOalTYDDO&vxp=mtr

turbo mani I think lambdaquiri is looking at casting some
but I believe Sykines simple one made recently should be
used instead but cast from iron once sorted for the process

I don't do turbo manifolds but I do have a design in my head that could work.

Yeah I didn't read his post very well. lol sorry OP

I have a turbo manifold for A series was going to use it for my A15 on blow through 38/36 weber with my T2860rs turbo

The manifold flange is a t25/28

Can run a t28 on an A series but need to have the different engine mounts as there are different types for a series engines its the low mount ones to bring the engine a little further away from the strut tower

Ran my other manifold on mates sedan with a t28 on A15 @11psi blow through made 167rwhp with 32/36 weber and equal length inlet manifold on bosch 40 fuel pump and xr6 turbo intercooler, electronic dizzy and bosch hec715 electronic ignition, tomei raising rate fuel reg and 5/16 fuel line and surge tank setup

Attach file:

---

  13630.jpg (56.72 KB)

Hey mate sent you a pm.

How much for the setup if still available