Hey Lobster,
If you accidently trash the rear screen I have a couple of spare ones stored behind my shed. I'm in Canberra too.

If you want to get someone to do it for you, ring Steve from "all suberbs windscreens". His prices are good and he does a good job plus he's into rallycars.

Lobster,

dattodude is right. I removed both front & back windscreens a few weeks ago. The back one properly: by running a screw driver around the edge, then pushing from the inside gently. The front one however I got impatient with and after running the screwdriver around it tried to lever it out. No Good!

Oh well, at least I have a spare.

Also new rubber is best way to go.

RockOn

Hey Lobster,
If its the old non laminated one then get rid of it and have someone come and install a new one.

In fact even if its a new one I'd get the pro's in to remove it. At $200 Approx for a new one if you bust it - its not worth the drama.

Easy..depending on how professionally it was installed/repaired over its life.

The hardest part is removing the stainless trims without bending them, or stretching them out of shape. This involves putting WD40 on the seals where the stainless is, letting it soak in, and using a small screwdriver to loosen the dirt/silicon used to hold the trim to the rubber, while carefully extracting the trim off the rubber.

To remove the windscreen, I generally carefully run a straightblade screwdriver between the window and the rubber on both sides of the window. This loosens up the glass/rubber bond from silicon, and "UV damaged rubber" from sticking to the glass.

Then I get in the car and using running shoes (soft bottomed) I sit in the seat, push it as far forward on the rails and them place my feet on the windscreen and push it out. If the seal is old, there's a good chance it will split.

Having a spare seal is a great idea. Then you can remove it like professionals, where they run a sharp knife around the window rubber and cut it out so the window can be easily popped out. When dealing with glass and pressure, always use as much surface area as possible when pushing it in or out.

Never lever the glass out with a scewdriver...NEVER!!! You will have nightmares of the vision and sound of the windsceen shattering in slow motion...

The other problem is getting the window back in if the seal has hardened. The use of the 4mm nylon rope is the go, but the rubbers need to be able to accomodate the string plus the thickness of the glass during the operation.

Chris

Can I do it myself, with help?

O should I try to get someone to come in and remove them?