Its a 60series box from a vannette has coloum shifter, just need to change rear selector housing.

A15 needs head gasket complete motor everything sump plug to carby!!

Plus 2inch exhaust system for ute.

0400747944
Adelaide.....

dude

if you were in perth, i would help you out. you would think that it would be easy to palm off a motor/gearbox/exhaust easy.
oh well, I am sure that someone will buy it. Sounds like a good deal to me.

WOW!
that is indeed a very good deal!
wish I could buy it!

I was always told that an exhaust should be 1" 4 every 1000cc in na form for the best compression, but ne way contact Nateron. He's in NSW and been in the prowl for an a15 and 5-spd.

So with your formula its only half an inch off and most exhaust shops sell 2 inch not 1.5 so its pretty good for the price.

Still for sale to best offer...

F.u- k didnt think it would be this hard at that price!!!!!!!!!!!

Quote:
Somebody check my maths, but the way i see it,
A 1000cc engine uses a pipe with a cross section of 0.7853" square inches
A 2000cc engine uses a pipe with a cross section of 3.1415" square inches
A 3000cc engine uses a pipe with a cross section of 7.0685" square inches

The 3 litre engine is 3 times the capacity, but uses a pipe that is 9 times the size.

Like i said, somebody check my maths please.

sorry matsfatdat, i've been looking at your avatar for 3 days now, just noticed you're also selling something....

is it hard to convert a column shift five speed to floor shift. or is it not possible.

if it is possible id like to no how.

Pitroad sells (or used to sell) a kit to convert from column to floor shift. This was for the 60-series trans.