To fit the E15 dissy into an A series you need to change the drive gear to the A series one. ( its been discussed heaps, so you will be able to find it with the search button if you really want it)
To mount the E15 dissy in the A series block you need the dissy mounting plate off of a 120Y A series onwards. ( just like on the right in the attached pic)
The mounting plate on the left is one Jeff Taylor made for me years ago for the E15 dissy to fit an A15, all 120Y onward A series will require the same. Early 1200 A series will require a different but similar modified mounting plate.

No pro-240c that is not what i'm refering to..
I have an electronic dizzy from an n12 pulsar with the e15 engine.
I know that this mod has been done and was after info on methods of mounting it to the a series block,the e15 dizzy has a different plate than the a12 dizzy.

If you had read the article that you linked too, you might have noticed this...
Quote:

(edit)
Converted,can you get some pics of the dizzy for others to see????

Ring Jeff Taylor at JTS Perfromance....I just picked up a converted E15 for my A series and it absolutely rips.

That is telling you how to fit a late model elecectronic dizzt to an early block.
Were you dropped as a baby or what?
I too would like to see some pics with a good descriptoin of how to fit an E15 dizzy to an "A" series motor.

are you talking about the mitsubishi distributor / E15 distributor conversion?

took me no time to find this and all the links for the mods are here too. this link was at the bottom of the opening page.

I checked the tech section first,as the information mainly refers to us spec factory distributors I posted my query...

I know people have done this conversion, and was hoping for some advice..

there is a huge tech article on this in the tech section with step-by-step instructions. i would suggest you try there first and then if you have any queries post them up.

good luck

Anyone????
I have my ute of the road and need to sort this as soon as possible...
Help,please ,please

Found myself an e15 dizzy today,cost me $20 bucks without cap or rotor.
New cap and rotor $30 bucks,not too bad really..

My question is how do i modify the mounting plate or dizzy itself to match the a12 block?????
Also what about wiring,do i need a new coil (i have a gt40),ballast resistor,relay etc...

I have taken plenty of pics and plan to post pics and description of install to helpout others planning this mod....