Quote:
:lol have you heard of internet bhp? same principle...

For my 1200 coupe way back at SCCA drivers school I Ran a stock motor with 3.90 rear end and 185/60 13's. The car would do maybe 6000 RPM and about 88 MPH range.

Currently with GX Cam , H-production head , 37mm / 30mm valves , dual valve springs , header , 2 inch exhaust and 32/36 Weber - the car will pull 8100 RPM although I shift at 7800 and best speed on a really fast track is about 110 MPH downhill. Most tracks I see about 98 MPH.

Tom

yep thats reasonable for a stock A12...

Although a stock A14 can rev alot harder (7,000rpm) heh Teretonga!!! Ah those were the days!

Anyway back to the question:-

There will be 3 bolt on things that will give you revs on an stock A series...
A set of extractors (or even a GX manifold) with a 2 1/2 inch system
A downdraught 32/36 Weber carb
Electronic Ign.
You get these 3 things and would wont believe its the same engine.
Then you can rev the guts out of it day and night, and if she ever broke you just buy another one for $20 and bolt all the gear back on again.

Quote:

Something's not right mate. What condition is your motor in? Are your compressions good? Is it in proper tune? Does it rev out in the first 3 gears? Do you have the original 4.1 ute diff on board? Are you trying this on public roads?

I read about every ones dattos reving to 8000rpm ??How?my A12 is flat out getting past 5000rpm.the A12 is all stock any ideas?Also how fast do the 1200 utes go flat out with a A12 and a 4spd?? mine is 80/82mph max thats my foot in the floor and 5200rpm.Thats it no more un till a down hill and a tail wind