i can definetly recommend andrews crossmember
i have nothing againest maddat but andrews x-member is by far cheaper and is still very professional
top bloke too great to do business with

cheers guys but i scored 1 cheap from someone close by but helped big time when my mates 180 sx blew a hose 5 mins from his house i am truely in debt a carton of cold beers!!

hi there. Just some advice on how you completed your conversion would be great. I have ca18det engine, gearbox, crossmembers and radiator. I have been told that with these, the radiator wont fit, and the gear shift sits too far back with the ca18det gearbox. Is this correct?

dunno just whack it in and tell us??

dunno just whack it in and tell us??

Do a search dude, all your answers are here.

hi all!!
i am about half way through my ca18det into 1200 ute conversion. i have used the crossmember for the engine and box from maddat. i also bought a hydraulic clutch kit and brake cable from them. so far so good..

i havnt fitted the gearbox just yet but am ready to do so. i went with the skyline 5 speed stumpy as i was told that there is no mods needed at all to fit it into the original tunnel and the shifter also lines up with the hole. i beleive this bearbox would have to be the way to go. although you will be paying for a second box, you can sell the ca box and you will be saving time and money in the tunnel work.

cheers guys, adam.

the radiator should fit, to make the conversion easier you should fit an auto tunnel to your car. can i post piccy;s somewhere here to show you where the shifter comes out through the floor? on my 1200 coupe
Heath