As i have no real knowledge of electronic dizzys apart from the real basics im asking here
i have an electronic distributor from an 86 c22 vanette (a15). Picture:



Where do the two little wires go from the dizzy?
I assume the blacks an earth ? maybe the other to the coil ?
Any help will be kindly accepted.
Cheers

This must be a way late model one, all the ones i seen here had a black ignitor box on the side, but still 2 wires. i think both go to the coil and they are +/- so one is ground and one is +12...
but check, since i have a weird ignition setup.. I use the coil + as power to my ignition box, use a seperate ground and use the coil - as a trigger signal for the ignition box. my coil is run by the ignition box directly.

Yeh i would say they bot goto the coil. Logic would say that the blue one would be positive and black negitive. But these are the exact same wire colours as a E15 electronic dizzy and they are the opposite way around. black/white is pos and blue is neg.

Try wiring it up, if it doesnt fire, swap em!

looks like you might want a fresh rotor too... Sure won't hurt...

it's interesting that that rotor has like the circular notches, all the ones i've seen here had a smooth radius.

yea i know, its shot
Anyone else have any confirmation?
positive to positive on coil and neg to neg on coil ??

Did you get this sorted Cheater?

I picked up an E15 dizzy the other day and it is the same.

The blue wire goes to the coil minus (-) and the black wire with the white stripe goes to the dizzy plus (+)

If you cock up the polarity, chances are you'll root it. Post a pic of the underside of the dizzy if it's not in the motor already. My NOS electronic dizzy has a clip on cap.

E16 dizzy running on A12

Blue goes to negative side of coil, Black/white goes to positive side of coil. Make sure you change the coil to suit electronic, wrong coil can also damage dizzy.

Talasas, are they your fingernails? How do you keep them so long and clean?