CA18 to go into my dat
so im new to this what other parts will i need?
really apreciate the help

its a lil expenseve that motor or maybe its realy low kms ?

youll need a diff new brakes a bigger gearbox tunnal a new fule tank a crossmeber to suit

thats a start for ya

CA18DET

<=== or search bar on left

hope these help

They probably are a bit more expensive over there because they are less common. However, I'm always skeptical when someone covers something in tyre shine when selling it because you know it's been cleaned and you can't tell where leaks etc are.

wd40 makes most motors look great

Tailshaft
New diff?
Fuel pumps/surge tank/fuel lines
New front suspension?

Make sure you have the wiring for the knock sensor (not in the main EFI loom)

Intercooler and radiator....and piping for both of those too.

Accelertor cables, hydraulic clutch, speedo cable, gearbox crossmember.

That will get you started....

With your conversion, i do a lot of components to make it a more simple. If you check out www.maddat.com.au there should be some gear that might help you out.

Cheers Scott

I can tell you the threaded sleeves I got from sssute are top class too, I can only assume all his conversion parts are as classy!

Thanks Ben.

i can second that for the maddat products..

i have also brought hydo clutch set up, throttle cable, dump pipe.. and also buy engine conversion kit..

A++