Musta been somewhere else I saw it. The new H165 units are about $1000 also (TRD brand).

I looked at the Pitroad site just a couple of days back & the H150 LSD is still on the NLA list, the same as it was when I checked a year ago. I was hoping that with enough interest they might have gone back into limited production, but apparently not.
Supply & demand control the market value & supply seems to be almost zero.

The Ford 9" is the sort of thing that you use with engines over 400hp, with torque to match, & a heavy car, but unless you have this much power [or more] & plan on flogging the living bejesus out of it, then the mere though of using a 9" Ford rear end in a small Datsun is downright laughable as the only things you'll get are an empty wallet, a bad ride & a lower performance than your car deserves as these suckers weigh heaps & suck up more power to just turn them then you even want to think about.

How is a Ford 9" going to help? That is way too heavy for a small-output engine.

If I recall correctly, Pitroad is selling new H150 LSD for $1000 USD.

HAHAHA! f*** I had a feeling you were gona say that.. Ohwell Ill probly splash out and get a costom 9" in the not to distant future.

According to Feral, these things cost as much as $1,800 Aus when new, depending on the exchange rate & who you bought it through.

I would suggest that $200 is probably below the reserve.

Thank's dogman. And gino I realy hav no idea what these thing's are worth, But is say $200 a fair amount or a joke? anyway I am interested so could you pleas email me at connorh@optusnet.com.au and I am in the melbourn area aswell.. Thank's a'lott

Quote:

This H150 LSD unit will not fit into the H145 differential carrier, it will only fit a H150 carrier from a 120Y or a Sunny [B310]

The whole differential assembly, however will go into the earlier H145 rear axle housing. To correct the misalignment that the H150 is said to have in the H145 housing, a 2mm spacer & a second gasket would be required.

No, i didn't buy it off ebay.

did you recently get this off ebay?

i believe it will fit into the 1200 sedan or coupe housing with the addition of a 2mm shim.
PM a offer of what it's worth to you.