did you have to modify the firewall?

that combo is ridiculously good Jake... very nice

no it wont damage the beaing because im using the s13 front end.. as for time i think its been about a year and who knows what the budget is... its as much as it takes to finish it.

lookin good mate.how longs it taken for you to get this far and what was ya budget

hey they look pretty sic oldschool plus newschool combo meal,plus 38 offset really?will that be bad for your bearings?

wow people i have finally gone and purchased my rims for the ute they are 16x7 +38 offset...and no spacers. fitted with kuhmo 205x40x16s... I was going to fit the superlites but they couldnt make them in the right offset. but now ive got didish

looking good dude the lower the better i recon it makes the ute look so much tuffer and the diff looks good to bud

as for pointers on doing the lips, i recommend using a piece of right angle along the entire length and then weld it all together it will be a good strong weld then.

as for the u bolts, i got new ones from pedders as the old ones would have been to short and about 10mm not wide enough.

as for the calipers i suppose ill put them on the back havent looked into it enough yet

Did u come across any problems with shaving the lip off the tray?
Iv thought about doing it but not too sure if there is any tricks or anything like that
Do u have any pointers that would help doing it?
Cheers

man that would look low as with 4 inches of lowering and the sills on the tray removed.