Fitted new tie rod ends, gearbox mount and had great luck with my original speedo cable, which as I read on the wiki would screw straight into my t-50 gearbox !!!!!! It did... I had plenty of nightmares about that one...

Had issues with the factory tach on the toyota motor so I picked up a nice 2" aftermarket tacho with green lighting to slot in under the cig lighter...

And some 6" speakers for my kick panels. Also dropped of some lines, needed a new braided clutch line because ca18 one for a maddat booster is too short and a brake line aswell.. Busy little bee

Excellent build those toyota motors are fairly bulletproof that motor is very popular here in south-africa they use the in a lot of convertions!!!

cheers, yeah i got the motor and box a bargain and could not say no!!!!! good cheap power.

went to wreckers today and picked up some wiper arms but they dont seem to fit?? not sure if im missing anything outside the car.. does anyone have a picture of the wiper area with arms removed???? i have a nut on the end but its way too small to fit in the wiper arm unit?????

picked up some little rubber bits i needed like for the bonnet stay, and around one of my locks on the door... some demister vents for the top of my dash etc.

and a coupe door mechanism as inside mine was bent stuffed and ruined by the previous owner.. will have to modify the long rod inside tho????

pic like this or from above

Attach file:

---

  SAM_8302.JPG (23.18 KB)

thats it!!! thankyou for taking that pic for me..

mine is exactly same but my wiper arms do not fit???? they are way too big to fit over that nut?? bought them from a wrecker maybe they are the wrong ones??

thanks again for the help, i love this forum :)

There are a couple different types, bolt on and slip on ones. Slip on ones I had had a fake nut on the tops.

now whe are getting somewhere - so im probably missing the fake nut which would be the right size for the wiper arms to slip on....

No there is no nut on the shaft of the other kind they have splines and the arm just slides on tightly- like a push on interface. The fake nut was on the out side to make them look bolt on

looks like ive got the wrong ones.... back to the drawing board/wreckers i guess.