bit of chopping of the rad support was all I needed to do - plus some mounting work.

It's on Page 5 of this site.

http://mildman.datsunprojects.org/White_index.htm

thanks there mildman ive checkout your build not bad, intercooler looks very neat sitting there,
with that amount of cutting i think i can live with that...
did ya end up painting it!..

Painting the intercooler you mean?

im running a 630 x 76 x 450 thats end to end

Quote:

sorry mate the car....

not bad at all there ben,
i see you didn't have to remove the centre upright support.....
question: on the peer mirrors, how did ya fitting them without damage the rubber?

I cheated a little with the upright support - I cut the bottom half of it off and let it get supported a bit higher up. It is now supported by the bar that holds the grill in.

As to you question: Quote:

I'm not sure what you mean by peer mirrors?

o ok that not so bad at least it does'nt push down when closing the bonnet............

sorry the peer mirror question was for crzy 1200ute

Do you guys think its impossible to fit an inteercooler behind the grill without cutting or majior cutting like some of you boys have done ?

looking at these pic that are up, i think there pretty good in getting them in with bugga all cutting at all,

you maybe have to get sumone to fab one with your car in there care...............