im running a 630 x 76 x 450 thats end to end

Painting the intercooler you mean?

thanks there mildman ive checkout your build not bad, intercooler looks very neat sitting there,
with that amount of cutting i think i can live with that...
did ya end up painting it!..

bit of chopping of the rad support was all I needed to do - plus some mounting work.

It's on Page 5 of this site.

http://mildman.datsunprojects.org/White_index.htm

the width and length thats ok, its the thicknest,
when you say minor mods what exactly do ya mean?, apron, radaitor support....etc

pics

I've fitted 450 x 300 x 76 - I made some minor mod (had to open up the rad support) otherwise fit OK.

thanks guys parden the punt im abit concern with the thicknest haha,
im sure length wont be a problem,....lol

i no by looking at i can make a couple changes to the rad support bracket just under the bonnet latch, but also i want to avoid cutting apron if possable.....i like the cooler of your there lachie

Here is a couple of pics of mine...




And with the grill on...

for "DAT12T"



click the [img] button then add the address (http:blahblah.jpg.. with NO!! [img.]..[/img.] in it.) into the box that pops up



im with bert, i cant see why you cant use a side mount IC like on a 180sx/s13, if you keep the ducting shield on you could easly scoop up the right amount of cold air.. they can cope on a sr20det with a t25 on 12-14psi..

At a pinch ours is 450x300x60, only done a trial fit with S13 rad but seems to fit with little mods.