Can someone tell me if we can use the datsun coil? I didn`t understand the wiring yet.

Yes, you can use the Datsun coil.


There are three wires coming out of the distributor:

1. Green wire - connect to IGN - (for example, hot side of ballast resistor

2. White wire - connect to minus(-) side of coil

3. Black wire - ground/earth. Connect to engine bolt.


What is the part numbers on the Distributor?

Hi dd sorry for the late reply but yesterday i couldn`t post anything don`t know why! I still didn`t understand very well how i`m going to make the wiring, can someone make a drawing of the connection? Regarding the number on the distributor i can`t tell you what is the number because it got a lot of numbers in the side can you tell me wich one is?

Write down all the numbers and post them here.

If it is Ford, the main number starts with an E for 1980s parts, or an F for 1990s parts.

I will put exactly what is on the side of the dizzy:

JGFFUX4->
0 237 601 013
87BF 12 100-HA

Thank you. Those numbers are from the electronic module. Are there any numbers or a Hitachi or Mitsubishi symbol on the distributor body? like this?






Ford Fiesta 1.1 Distributor

here`s the pics of all the numbers in the side:

Attach file:

---

  MVC-004F.JPG (61.09 KB)


  MVC-003F.JPG (61.97 KB)


  MVC-002F.JPG (32.73 KB)

UPDATE: That is a Bosch JGFFUX4 distributor (of the type '0 237 601 013')

It looks visually similar to an MG/Austin distributor which also fits in a Datsun A-series engine