hi all, doing the ca thing in the 1200, was wondering what dump pipe people have used?? does the std one fit??

cheers dennis

if you go the ca make sure the motor is bout 10-15mm off the firewall or you wont be able to use the standard dumpy as it WILL hit the idolarm on the leftside front of dumpy if you bring it to far forwards, as i found out i now using a sr one elonggated the hole to fit, i will be going custom stainless pipe soon....

edit: dont go over a inch-inch1/2 from wall

Using an SR20 dump pipe..even the SR20 cast pipe works great. As hotrocket says, one bolt hole needs to be elongated to use the ca18 T25 turbo, unless you are already putting an sr20 t28 or t25g turbo onto the CA18.

I think you'll have to custom make the front pipe to the catalytic converter using mandrel bends anyway.

Std one fits for me - I'm using a 'ca18detman' crossmember.

sweet, i'm using a gt2560 after market one, so the sr dump will be fine. Next question, does anybody have one?

cheers dennis