have for sale two dump pipes suit ca/sr.

1: std sr dump, with a 2.5" pipe hanging off it, perfect for street use with a ca conversion. want $50.

2: an after market stainless steel one, never used, $65.

reason for selling, hits the chassis rail with the new gt2560r.

will suit std turbo.

If really needed, have std turbo for sale as well...

call or message dennis 0402 415 355

Attach file:

---

  std dump.jpg (35.78 KB)


  GetAttachment.jpg (38.01 KB)

geez, you must really have a low hanging motor. What crossmember/engine mounts are you using? Had you considered cutting and rotating the SR cast manifold output flange?

Normally the worst thing that happens is the dump pipe flange is 10-20mm away from the trailing arm bracket.

its the new turbo that i thinks sits round more than the original...

a custom dump pipe will sort all the problems out!

Hmm..are you using the GTR twin turbo style exhaust flange or something?

Any Garrett/HKS turbo I've dealt with has the same angles on the exhaust flanges.

using the gt25/60r on a std manifold. seems the exhaust side angles futher round, anti clockwize from the front of the motor.

using a maddat cross member with their rubber engine mounts.

should have left it std...