[IMG]http://img703.imageshack.us/img703/5156/img0447b.th.jpg[/IMG]
[IMG]http://img683.imageshack.us/img683/6426/img0446wt.th.jpg[/IMG]
[IMG]http://img844.imageshack.us/img844/3047/img0445h.th.jpg[/IMG]
[IMG]http://img132.imageshack.us/img132/6666/img0443kb.th.jpg[/IMG]
[IMG]http://img341.imageshack.us/img341/8106/img0432k.th.jpg[/IMG]

updated pics of body work which has been done over two weekends.Rolled the front and rear guards ready for some bigger wheels and tyres. A lot easier than I had expected especially the fronts.

got em to work for ya dude

Bugger of a job fixing hail damage, great work.

looking at fitting Cusco adjustable camber tops that I have purchased. What do I need to do to maintain my current ride height. I already have coilovers that are wound down as far as possible. Do I need to cut springs and also reduce the strut height if so by how much normaly.

Thanks

if you are putting the tops in they should lift it a little ,so just wind the coil overs down till your happy with the height then use a tape messure to messure the highest point in the front wheel arch to the floor and mathc it with the other side of the car ,then it should be all good

and lay those wheels in!

respray has been completed and fiberglass gx bonnet has arrived, what do you guys think keep it black or paint it the same color as the car?. Theres just a few small things that need to be touched up.

But my dad did a awesome job with the body work getting nearly all the dents out. Tell us what you think.

looks awesome mate, where do you get the GX hoods from?

Very nice job!! I like it just the way it is!