cool thanks,
next question

is it possible to use the stock dump pipe, using basically a mad dat crossmember to mount the motor?

check this postca wiring

Just curious if there is any tricks?
wiring is not usually a big deal for myself, i enjoy it

going to get ecu to engine loom, most stuff will plug straight up to motor, but what other inputs does the ECU require other than engine sensors?

inputs:
permanent power/ground
ignition signal
anything from tacho, speedo, gearbox? etc?

outputs:
fuel pump?
thermo fan?

pointing me in the direction of a wiring diagram would prob answer my questions