BUMP

Nice looking setup.

I wonder if the carburettor would fit under the bonnet?

I'd like this setup but seeing that photograph showing the height of the carby in comparison to the rocker cover, I'd be a little concerned.




Can you tell me what that measurement is & I'll check?

doesnt look any higher than a stock air filter on the hitachi set up to me. you could do a dodgey and cut the holley filter in half height wise.

Sure it restricts air inlet volumes but it would fit.

if you sit a 32/36 webber on top of the rocker cover that will be about the height. if it hits the bonnett you could just cut a neat hole where it is hitting and put a nice little bonnett scoop of a nissan patroll or something. wouldn't be that hard to make fit.

Oh okay, yeah that isn't an option for me.

Either way I have too much on my hands anyway.

You could also use a 'pancake' filter from ram-flo (I think) they are very thin but make up for the induction area because they have a larger perimeter.

It's neat setup, and very well priced I think. All the best.

thanks mate

BUUMP

pm sent

PM replied

sold pending payment