good work with the nuts....

what a prick of a spot to weld.

keep up the good work

nice andy

Got a little done today. Had to weld in some new nuts for the Sway bar bolts and drip tray hence why i stepped the cut out but was still fiddly to get to. Had to cut out a small section of rust in engine bay behind the Castor Rod mount so that made it easier to get to other side. The one closest to front of car was hardest had to get right down in the rail. Then welded up rust repairs with some new sheet. Progress is great.

Attach file:

---

  Progress 009.jpg (87.76 KB)


  Progress 011.jpg (112.87 KB)

yeah my drivers side is worse than the passengers too. weird that- another coincidence

O.k update time. The citrus stripper is good on acrylic but wont hardly penetrate 2k. Most of the front of the ute and outer cab is paint stripped to bare metal. We decided to get going on cutting out the rust for new metal to go in as we will do all the work on front and cab and then do the quarters and rear. 95% of the rust and bad bits are in the drivers side. The passenger side is very good with just little holes in a couple of spots.

Attach file:

---

  Progress 004.jpg (133.48 KB)

Thanks guys. Nick your coupe was done in 2 pak mate so any stripper will just fry the paint up and basically flake off.

great result

any luck with that tacho etc?

that stuff looks like it does a good job andy, so no runny mess at all? Could be good for me to use on my coupe?

yes acrylic is bad news with automotive stripper soooo messy, i like the looks of this citrus stripper i may have to search for some, top stuff Andy!

the citrus striper sounds good.